9,000 lb Two Post Lifts
9000AE Two Post Lift
Lift Features

•Dual cylinders with low Friction Chain Rollers
•Low profile automatic arm restraints
•Stackable drop-in height adapters
•Free mounting hardware
•Powder-coated paint finish
Lift Specifications
Lift capacity-9,000lbs.
Style-Asymmetric or symmetric
Lifting speed-50seconds
motor rating-2hp 220v 20amp
overall width-134"
Overall height-142"
Lifting height(no extension)-70.5"
Lifting height(with extension)-75.5"
Low pad height-4.5"
Width between columns-109"
Drive thru width-92"
Height extensions-1.5" and 5" included.
Shipping weight-1,500 lbs.
9000FE Two Post Lift
Lift Features
•Dual cylinders with low friction chain rollers
•Low profile automatic arm restraints
•Stackable drop-in height adapters
•Free mounting hardware
•Powder-coated paint finish
Lift Specifications
Lifting capacity-9000lbs
Style-Symmetric
Lifting speed-50 seconds
Motor rating-2hp 220v 20amp
Overall width-134"
Overall height-111.5"
Lifting height(no extension)-70.5"
Lifting height(with extension)-75.5"
Low pad height-4.5
Width between columns-109"
Drive thru width-92"
Height extensions-1.5" and 5" included
Shipping weight-1,500 lbs.
Model# 9000AE
Model# 9000FE
1-877-2ARESCO
Automotive Repair Equipment Supply COmpany
Specializing in car & truck lifts, brake lathes, pipe benders, tire changers, and wheel balancers, and much more! ARESCO, Inc. is the source for all of your automotive equipment needs. We carry a full line of equipment and replacement parts for most makes and models. With over 25 years of experience in the automotive industry, we at ARESCO are committed to providing our customers with quality products and service.
or 1-877-227-3726
1. Concrete shall have compression strength of at least 3,000psi and a minimum thickness of 4” in order to achieve a minimum anchor depth of 3 1/2”. If the top of the anchor exceeds 2” above the floor grade, you DO NOT have enough depth.
2. Use holes in column base plate as a guide before drilling the 3/4”diameter holes in the concrete floor. Make sure the hole distance from the edge is not less than 6”. Hole depth should be a minimum of 4”, it is recommended to drive through the 4” concrete, unless you have a high water table.
3. CAUTION: DO NOT install on asphalt or other similar unstable surface. Columns are supported only by anchoring into the floor.
4. Shim each column base until each column is plumb. If one column has to be elevated to match the plane of the other column, then full-size base shim plates should be used (Reference Shim Kit) torque anchors to 130 ft-lbs. Shim thickness MUST NOT exceed 3/8” when using the 5 1/2” long anchor provided with the lift. Adjust the column extensions plumb.
5. If anchors do not tighten to 130 ft-lbs installation torque, then replace concrete under each column base with a 4’X4’X6” thick 3,000psi minimum concrete pad keyed under and flush with the top of existing floor. Let concrete cure before installing lifts and anchors.
Concrete Requirments
71 W. Walton Blvd , Pontiac MI. 48340
Site Map
Home
Two Post Lifts Four Post Parking Lifts Heavy Duty Lifts Alignment Lifts Scissor Lifts Motorcycle Lifts
Shop Equipment Brake Lathes Pipe Benders Alignment Machines Wheel Balancers Tire Changers Air Compressors
Copyright©2014 www.aresco.org all rights reserved web design by M.Miller