HD9 st bendpak

The HD-9ST car lift is about the size of a typical parking space and will truly maximize your valuable floor area. Use the HD-9ST for storing ATVs, snowmobiles, jet skis, golf carts, boats or just about anything else that needs to be off the ground. Now you can finally make use of that wasted vertical space above your car. If you’ve got at least standard 8-foot ceiling, this lift will work for you.
Just don’t make the mistake of calling the HD-9ST a “hobby lift.” Our expert engineers have packed this model with advanced features that were previously only found on commercial-grade designs. Plus, it’s a BendPak, so you know this car lift backed by over 40 years of experience and a reputation that carries just as much weight as the lifts themselves. We’re proud to have these HD-Series lifts in our lineup, and you’ll be proud to have one in your shop or garage.

The HD-9ST is the narrow version of this lift. If you are looking for a standard-width model, consider the HD-9.

Lifting capacity*: 9,000 lbs. / 4,082 kg *Max capacity / front axle: 4,500 lbs. / 2,041 kg
*Max capacity / rear axle: 4,500 lbs. / 2,041 kg

•Overall width: 99-3/4" / 2,534 mm
•Outside length: 174" / 4,420 mm
•Overall length: 200" / 5,080 mm
•Height of columns: 88" / 2,235 mm
•Runway min height: 4-1/2" / 114 mm
•Max rise: 70" / 1,778 mm
•Max lifting height: 74-1/2" / 1,892 mm
•Width between posts: 89-3/4" / 2,280 mm
•Runway width: 19" / 483 mm
•Width between runways: 37-1/2" / 952 mm
•Runway center line: 56-1/2" / 1,435 mm
•Outside edge of runways: 75-1/2" / 1,918 mm
•Length of runways: 164" / 4166 mm
•Min. wheelbase @ rated capacity: 115" / 2,921 mm
•Min. wheelbase @ 75% capacity: 100" / 2,540
•Min. wheelbase @ 50% capacity: 85" / 2,159 mm
•Min. wheelbase @ 25% capacity: 70" / 1,778 mm
•Locking positions: 12
•Lock spacing: every 4" / 102 mm
•Lifting time: 45 sec
•Motor: 220 VAC / 60 Hz / 1 Ph
•Shipping weight: 1,872 lbs. / 851 kg
•Shipping dimensions: 180" x 22" x 40" / 4,572 mm x 559 mm x 1,016 mm

Note: An air supply (minimum: 30 psi / 3 CFM) is required for the safety-lock mechanisms to disengage. It is solely the responsibility of the end-user to provide, install and maintain the air supply.

*Not all BendPak lift models meet the standards as prescribed by ANSI/ALI ALCTV-2006 or ANSI/UL 201. Consult www.autolift.org for a complete list or contact BendPak via contact@bendpak.com.

Specializing in car & truck lifts, brake lathes, pipe benders, tire changers, and wheel balancers, and much more! ARESCO is the source for all of your automotive equipment needs. We carry a full line of equipment and replacement parts for most makes and models. With over 25 years of experience in the automotive industry, we at ARESCO are committed to providing our customers with quality products and service.